VTR VQ35 STAGE 2 LONG BLOCK
STREET FIGHTEN STAGE 2 LONG BLOCK - “THE KILLER”
WHY VTR ENGINES ARE THE BEST VQ ENGINES AVAILABLE
OUR STAGE II BLOCK IS A SERIOUS ENGINE CUSTOM BUILT! CUSTOM V.T.R. PARTS ARE USED TO BUILD THIS ENGINE ALL CUSTOM V.T.R. PARTS WERE DESIGNED WITH THE MOST EXTREME RACE CONDITIONS IN MIND, THERE ARE NO BETTER PARTS AVAILABLE WITH EXCEPTION OF OUR STAGE 3 ENGINES!!
HOW MUCH POWER DO STAGE 2 ENGINES HOLD?
STAGE 2 BLOCKS HAVE BEEN TESTED IN BOTH AN 8 SECOND PERFORMANCE MOTORSPORT DRAG RADIAL CAR & IN STEVE GILBERT’S WINNING S.C.C.A. TWIN TURBO B / PREPARED ROAD RACE / TIME ATTACK CAR.
ALL VTR ENGINES ARE PROVEN NOT TO OVER HEAT, LIFT HEADS OR SPIN BEARINGS. WE DON'T SELL UNPROVEN OR UNTESTED PRODUCTS. WE SELL WHAT WE RUN AND THIS V.T.R. STAGE II BLOCK & HEADS ARE PROVEN WINNERS….NOT INTERNET HYPE, REAL PRODUCTS, REAL PEOPLE, REAL RAW POWER!!!
STAGE 2 ENGINE BLOCK
PARTS:
- DARTON SLEEVED BLOCK
- VTR ARP H STUDS ½-13
- VTR CP PISTONS W/866 & L.G.P.
- VTR TOTAL SEAL RINGS
- ARP MAIN STUD KIT
- ACL/CALICO MAIN BEARINGS
- ACL/CALICO ROD BEARINGS
- NISSAN THRUST WASH
- GTR SKYLINE FACTORY HEAD GASKETS
- CARRILLO H BEAMS W/WMC BOLTS
MACHINE WORK
- CNC INSTALL MID KIT
- DRILL & TAP 1/2-13 H-BOLT HOLES
- DECK SURFACE OF BLOCK
- HAND FINISH DECK TO # 50 RA
- POWER HONE WITH PLATE
- LINE HONE
- MICRO POLISH RADIUS OIL HOLES
- REMOVE GALLEY BALLS, FLUSH CLEAN
- DRILL & TAP FOR SET SCREWS
- RESIZE RODS FOR ADDITIONAL CLEARANCE
- BALANCE COMPLETE ROTATING ASSEMBLY
- FILE FIT RING TO BORE
STAGE II CYLINDER HEAD
MACHINE WORK / LABOR
- COMPLETE FULL RADIUS VALVE JOB
- DECK SURFACE OF HEADS
- DRILL ½ HOLES
- LAP ALL VALVES
- ASSEMBLE COMPLETE ASSEMBLY/
- ADJUST ALL VALVES & SUPPLY BUCKETS
- FULLY PORTED INTAKES
- FULLY PORTED & POLISHED EXHAUSTS
- (30 HRS OF PORTING TIME)
FERREA VALVE COMPONENTS
- 1MM O.S. INTAKE VALVES
- 1MM O.S. EXHAUST VALVES
- VITON VALVE SEALS
- DUAL SINGLE VALVE SPRINGS
- 4130 CHROME MOLY LOCKS
- TITANIUM RETAINERS
- LOWER RETAINER
OUR ENGINES ARE PROVEN NOT TO OVER HEAT, LIFT HEADS OR SPIN BEARINGS. WE DON'T SELL UNPROVEN OR UNTESTED PRODUCTS. WE SELL WHAT WE RUN.
ALL FACTORY PARTS IE: GASKETS, SEALS, SILICONE,
TENSIONER ARE ALL EXTRA! EXCEPT HEAD GASKET
COMPLETE ENGINES ARE PRIMED & TIMED AND READY TO GO!
***ALL STAGE 2 ENGINES IN DYNO CHARTS HAVE BEEN TUNED USING HYDRA EMS***