VTR Stage 2 "The Killer" 2JZGTE Engine

Highlights:

• Proven combination that will net over 1000WHP!
• Eliminates the guess work of the right combination for your setup
• Fully developed, machined, built and assembled IN HOUSE

All engines are machined and assembled at our own facility. All combinations are developed through vigorous testing, both on the dyno and racetrack. We race what we sell. There are no other parties involved. We stand behind every engine built! Vinny Ten has been building some of the worlds fastest import engines over the past 25 years, there is no other company that can make that claim. This engine is an excellent choice for any level drag racer, road racer, autocross or if you just want to have a bad ass street car, we can assure you, you will not be disappointed.

Vinny Ten Racing never uses “off shore” internal engine components. All engine components are made in the U.S.A. No cheap knock offs in any of our engines. We only use the highest quality internal engine components made by American workers.

FEATURES:

SHORT BLOCK MACHINE WORK:

• Drill & Tap ½-13 H-Bolt holes
• Deck surface of block
• Hand finish deck to #50 RA Power Hone with plate
• Line hone
• Micro polish radius oil holes
• Remove galley galls
• Flush, clean, drill & tap for set screws
• Resize rods for additional clearance
• Balance complete rotating assembly
• File fit ring to bore


Short block parts:
• VTR ARP Head Studs ½-13
• VTR CP pistons w/866 & L.G.P
• VTR Total seal rings
• ARP Main stud kit
• ACL/Calico coating main bearings
• ACL/Calico coating rod bearings
• Toyota thrust washers
• Carrillo H beam w/wmc bolt

CYLINDER HEAD WORK:

• No head porting at this time
• Complete full radius valve job
• Install valve guides
• Deck head
• Vacuum test
• Machine/deck intake flange
• Machine/deck exhaust flange

Cylinder head parts:
• Complete Ferrea valvetrain
• 1mm exhaust valves
• 1mm Oversize intake valves
• Dual valve springs
• Bronze valve guides
• Chromemoly valve locks
• Viton valve seals
• Titanium retainers
• Crower Stage 0 cams TBD
• Crower adjustable cam gears

Additional parts:

• Gates Timing belt
• Factory Oil pump
• Factory Water pump
• Engine gasket kit

FINAL ASSEMBLY:

• Assemble Head to block
• Install water pump/oil pump
• Degree Cams
• Deliver a complete long block ready to start